如何更换装载机油过滤器?

如何更换装载机油过滤器?

工具:

  • wrench
  • socket set
  • oil filter wrench
  • new oil filter

步骤:

  1. Park the vehicle on a level surface and apply the parking brake.
  2. Locate the oil filter. The oil filter is typically located near the engine block or near the rear of the vehicle.
  3. Disconnect the oil filter from the engine. Use the wrench to loosen the oil filter nut and remove the oil filter.
  4. Allow the old oil filter to drain completely. This may take a few minutes.
  5. Install the new oil filter. Hand-tighten the oil filter until it is snug.
  6. Tighten the oil filter nut with the wrench. Tighten the nut in a star pattern, tightening each bolt a little bit at a time until the filter is snug.
  7. Replace the oil filter cap.
  8. Start the vehicle and check the oil level. Add oil if necessary.

提示:

  • Use a new oil filter.
  • Tighten the oil filter nut evenly.
  • Be careful not to spill oil.
  • If you are not comfortable changing an oil filter, you can take the vehicle to a mechanic.
相似内容
更多>